Gasket Generator
Flat gaskets, flange gaskets and O-rings in any size
No printer?
Printaro can print this design for you. Copy the link to your design and paste it in your message, so we know exactly which settings you chose.
Keep the tools free
Found this useful?
These generators are free to use. If one saved you time, a small Ko-fi donation helps pay for hosting, rendering and new tools.
About this generator
A gasket for the tap, the pump, the lid or the lamp, in a size no shop has.
How to use
- Pick the type and measure the old gasket or the parts it sits between.
- Fill in the sizes.
- Print it flat in TPU.
Printing tips
- TPU 95A or softer for anything that has to seal. Print slowly, with 100 % infill.
- A printed gasket seals against splashes and low pressure. Do not use it for gas, fuel, drinking water under pressure or hot parts.
- Print two thin gaskets rather than one thick one if the surfaces are uneven.
Helpful guides
Frequently asked questions
Is it watertight?
Layers leave tiny grooves, so it seals well against drips and dust but not against pressure. Tightening it between flat surfaces helps.
What is the bolt circle?
The diameter of the circle that runs through the centre of every bolt hole. Measure hole to opposite hole, centre to centre.
