Push Rivet
Two-part rivets you fit and remove by hand
No printer?
Printaro can print this design for you. Copy the link to your design and paste it in your message, so we know exactly which settings you chose.
Keep the tools free
Found this useful?
These generators are free to use. If one saved you time, a small Ko-fi donation helps pay for hosting, rendering and new tools.
About this generator
A fastener for when a screw is too much: no thread, no tools, and it comes out again.
How to use
- Measure the hole and the total thickness of the parts.
- Print the body and the pin.
- Push the body through, then push the pin in until its head is flush.
Printing tips
- Both parts print head down, without supports.
- PETG or nylon: the legs have to bend without snapping.
- To remove it, lever the pin head up with a fingernail or a small screwdriver.
Helpful guides
Frequently asked questions
How strong is it?
It holds panels and covers in place. It is not for loads that pull the parts apart.
The legs break when I push the pin in. What can I do?
Use PETG and raise Fit a little. PLA is too brittle for the legs.
