Add text to STL: curved text on your own model BETA
Open your own STL, type a name and click where it goes. Bend it into an arc to follow a round edge, or wrap it around a mug or a pen. Download the model with the text as STL or as a two-color 3MF.
Private by design. Your file stays on your computer. It is opened and changed in your browser; nothing is uploaded.
How it works
- Open an STL file, or drop it on the viewer.
- Type your text and pick a font and size.
- Click the model where the text should go. Click again to move it.
- Choose Curve to bend the text along a round edge, or Cylinder to wrap it around a round surface.
- Choose raised or engraved, make the STL or the two-color 3MF, and download it.
Questions
Is my file uploaded?
No. The page opens the file in your browser and builds the text there, with the same OpenSCAD engine our generators use. Nothing about your model is sent to us. The finished file is stored in this browser for the download page. Its download link expires after one hour; expired files are cleared when another export is successfully stored or you clear this site's browser storage. Closing the tab or browser does not guarantee deletion.
How large can my file be?
Up to 100 MB and 3 million triangles. Above 1 million triangles adding the text can take a while; on a phone, files under about 30 MB work best.
How do I make text follow a circle?
Choose Curve, then click the centre of the round shape the text should follow, such as the middle of a mirror or a medallion. The tool measures the round edge around your click and puts the text just outside it; a yellow circle shows the curve the letters stand on. If your shape has no clear edge, set the curve radius by hand. Over the curve puts the text along the top of the circle, under the curve along the bottom; Rotate turns it around the centre.
What does Cylinder do?
It wraps the text around a round surface such as a mug, a vase or a pen. When you click the model the page measures the radius there; you can change it if the measurement is off.
Why is engraving not possible on my model?
Cutting text into a model needs a closed (watertight) mesh. Many downloaded STL files have small holes. Repair the model in your slicer or a mesh tool, or use raised text: that works on any model.
What is the difference between the STL and the 3MF?
The STL is one body with the text merged in, for a single color. The 3MF is a Bambu Studio and OrcaSlicer project with the model and the text as two parts in two colors, ready for the AMS.
May I use this on someone else's model?
That depends on the model's license. Many models allow personal changes but not selling them. Check the license where you downloaded it.