Hole Plug
Snap-in plugs for holes in panels and furniture
No printer?
Printaro can print this design for you. Copy the link to your design and paste it in your message, so we know exactly which settings you chose.
Keep the tools free
Found this useful?
These generators are free to use. If one saved you time, a small Ko-fi donation helps pay for hosting, rendering and new tools.
About this generator
An unused cable hole in a desk, a drilled hole in the wrong place, an opening in an enclosure: measure it and close it.
How to use
- Measure the hole and the thickness of the panel.
- Pick snap-in for a through hole, push-in for a blind hole or thick wood.
- Print it head down and press it in.
Printing tips
- Prints head down, without supports.
- PETG legs spring better than PLA and survive being taken out again.
- For a tight hole, raise Fit a little. For a loose one, set it to 0.
Helpful guides
Frequently asked questions
The plug falls out. What should I change?
Check the panel thickness first: the barb must sit just behind the panel. Then lower Fit.
Can I print it in the color of my furniture?
Yes. It is one part, so any filament works: white, black and wood tones are the usual choices.
