Desk Grommet
Cable pass-throughs for any desk hole
No printer?
Printaro can print this design for you. Copy the link to your design and paste it in your message, so we know exactly which settings you chose.
Keep the tools free
Found this useful?
These generators are free to use. If one saved you time, a small Ko-fi donation helps pay for hosting, rendering and new tools.
About this generator
Tidy up the cable hole in your desk. Enter the hole diameter and desk thickness, and the grommet and its slotted cap print side by side.
How to use
- Measure the diameter of the hole in the desk.
- Set the sleeve length to roughly the desk thickness.
- Choose the cable slot width for your cables.
Printing tips
- Print the grommet flange-down, as exported.
- The sleeve is 0.4 mm smaller than the hole for an easy fit.
Helpful guides
Part of a project
- Tidy the cables on your desk: Clips, channels and labels that get cables off the floor and out of sight.
Frequently asked questions
Does the cap stay in place?
It sits in a recess in the flange, resting on the sleeve wall.
How do I measure the hole?
Measure the diameter of the hole in the desk and enter it. The sleeve is made 0.4 mm smaller, so it slides in easily.
