Power Strip Holder
Brackets that hold a power strip under the desk
No printer?
Printaro can print this design for you. Copy the link to your design and paste it in your message, so we know exactly which settings you chose.
Keep the tools free
Found this useful?
These generators are free to use. If one saved you time, a small Ko-fi donation helps pay for hosting, rendering and new tools.
About this generator
The power strip off the floor and out of sight, with the switch still in reach.
How to use
- Measure the width and height of your power strip.
- Choose screws or tape.
- Print two brackets, fix them a strip length apart and press the strip in.
Printing tips
- Print standing on end, as shown: the lips can then spring. No supports.
- PETG lips survive pressing the strip in and out. PLA can crack.
- Under a desk, use screws: tape lets go when it gets warm.
- Mind the screw length under a desk top.
Helpful guides
Frequently asked questions
How many brackets do I need?
Two for a normal strip. Add a third in the middle for one longer than 40 cm.
The strip is hard to get in. What can I do?
Reduce the lip, or slide the strip in from the end.
