Cable Raceway
A cable channel with a snap-on cover
No printer?
Printaro can print this design for you. Copy the link to your design and paste it in your message, so we know exactly which settings you chose.
Keep the tools free
Found this useful?
These generators are free to use. If one saved you time, a small Ko-fi donation helps pay for hosting, rendering and new tools.
About this generator
Cables in a channel look like someone planned them.
How to use
- Count the cables and set the inside width and height.
- Set the length to your bed, and print as many sections as you need.
- Fix the channel, lay the cables in and click the cover on.
Printing tips
- Both parts print flat, open side up. No supports.
- Sections butt end to end; print the same settings for a long run.
- PETG covers click on and off many times. PLA covers can crack at the legs.
- Match the wall color, or print in white and paint it.
Helpful guides
Part of a project
- Tidy the cables on your desk: Clips, channels and labels that get cables off the floor and out of sight.
Frequently asked questions
How many cables fit?
A 20 x 12 mm channel takes about four ordinary power or HDMI cables. Leave some room: tightly packed cables push the cover off.
How do I get the cover off?
Squeeze the channel walls slightly and lift the cover at one end.
