Phone Tripod Clamp
Screw clamp that holds a phone on a tripod
No printer?
Printaro can print this design for you. Copy the link to your design and paste it in your message, so we know exactly which settings you chose.
Keep the tools free
Found this useful?
These generators are free to use. If one saved you time, a small Ko-fi donation helps pay for hosting, rendering and new tools.
About this generator
Put your phone on any tripod or selfie stick. Turn the knob to clamp phones from narrow to wide.
How to use
- Set the phone width range and thickness (measure with the case).
- Print the three parts as exported.
- Press a 1/4"-20 nut into the hole underneath. Screw the knob into the base, hook the sliding jaw onto the screw tip from above and drop its key into the groove.
Printing tips
- PETG or PLA with 4 walls.
- If the screw binds, raise the clearance by 0.05 mm.
Helpful guides
Frequently asked questions
How many parts are there?
Three: a fixed jaw, a sliding jaw and a printed M10 screw that pushes it. Underneath is a trap for a 1/4"-20 nut for the tripod.
The screw is hard to turn.
Raise Screw clearance by 0.05 mm and print again.
