Handlebar Mount
Clamp a GoPro mount to a bike or tube
No printer?
Printaro can print this design for you. Copy the link to your design and paste it in your message, so we know exactly which settings you chose.
Keep the tools free
Found this useful?
These generators are free to use. If one saved you time, a small Ko-fi donation helps pay for hosting, rendering and new tools.
About this generator
Put an action camera or a light on your handlebar, stroller or roof rack.
How to use
- Choose the bar diameter.
- Print both halves with the flat side down.
- Clamp with two M4 bolts and nuts (nuts go in the lower half).
Printing tips
- Use PETG or ASA outdoors.
- A strip of rubber inside the clamp stops it from rotating.
Helpful guides
Frequently asked questions
Which bar diameter do I have?
Measure the bar where the mount goes. 22.2 mm is common near the grips, 31.8 and 35 mm near the stem of modern bikes.
How do I stop it from rotating?
Put a strip of rubber inside the clamp and tighten the M4 bolts evenly.
