Kickstand Foot
A wider foot for a kickstand on soft ground
No printer?
Printaro can print this design for you. Copy the link to your design and paste it in your message, so we know exactly which settings you chose.
Keep the tools free
Found this useful?
These generators are free to use. If one saved you time, a small Ko-fi donation helps pay for hosting, rendering and new tools.
About this generator
Stop the bike from tipping over at the campsite or on the beach.
How to use
- Measure the end of the kickstand.
- Print with the plate on the bed.
- Push it onto the stand. A drop of glue makes it permanent.
Printing tips
- PETG or ASA: they handle sun and knocks better than PLA.
- Use 4 walls and 30% infill.
Helpful guides
Frequently asked questions
How do I measure the stand?
Measure the width and depth of the end of the stand where the foot goes, or its diameter if it's round.
It falls off when I fold the stand.
Lower Fit clearance by 0.2 mm, or glue it on.
