Headrest Hook
A bag hook for the back of a car seat
No printer?
Printaro can print this design for you. Copy the link to your design and paste it in your message, so we know exactly which settings you chose.
Keep the tools free
Found this useful?
These generators are free to use. If one saved you time, a small Ko-fi donation helps pay for hosting, rendering and new tools.
About this generator
Shopping bags that do not tip over at the first corner.
How to use
- Measure a headrest post.
- Set the reach and the size of the hook.
- Print it lying flat and push it sideways onto the post.
Printing tips
- PETG, ABS or ASA. A car in the sun gets hot enough to bend PLA.
- Print lying flat, channel up, as shown.
- The hook holds itself by tilting against the post under load. If it slides, raise Block height.
Helpful guides
Frequently asked questions
Do I need to take the headrest off?
No. The block is open on one side and pushes onto the post.
How much can it carry?
A full shopping bag of a few kilos. For more, increase the hook thickness.
