Gyro Rings
A print-in-place gyroscope of nested rings
No printer?
Printaro can print this design for you. Copy the link to your design and paste it in your message, so we know exactly which settings you chose.
Keep the tools free
Found this useful?
These generators are free to use. If one saved you time, a small Ko-fi donation helps pay for hosting, rendering and new tools.
About this generator
Print it, pop the rings loose, and try to put it down again.
How to use
- Choose the number of rings and the diameter.
- Print it flat.
- Push each ring out of plane to break its pivots loose, then spin.
Printing tips
- No supports: the pivots are 45° cones.
- Silk and multicolor filaments look best on this one.
- If a ring will not come loose, raise Pivot clearance by 0.05 mm.
Helpful guides
Frequently asked questions
Can the rings come out?
No. Each pivot is a cone that reaches into the next ring, so the rings are captive.
How many rings fit?
Each ring needs its width plus the gap. At 60 mm, four rings of 4 mm leave a comfortable centre.
