Calibration Cube
XYZ cube with engraved axes
No printer?
Printaro can print this design for you. Copy the link to your design and paste it in your message, so we know exactly which settings you chose.
Keep the tools free
Found this useful?
These generators are free to use. If one saved you time, a small Ko-fi donation helps pay for hosting, rendering and new tools.
About this generator
Measure the printed cube with calipers along X, Y and Z to check dimensional accuracy, steps per mm and flow.
How to use
- Pick a size (20 mm is standard).
- Print it at your usual settings.
- Measure each axis: the letter tells you which is which.
Printing tips
- Measure in the middle of each face, not at the edges.
- If X and Y are off by the same amount, check flow before steps per mm.
Helpful guides
Part of a project
- Tune a new printer or a new filament: Five short test prints, in the order that makes each one useful for the next.
Frequently asked questions
How do I measure it?
Measure each axis with calipers in the middle of the face, not at the edges. Compare with the size you set.
X and Y are both off by the same amount.
Check your flow rate first. Over- or under-extrusion changes every outside size by about the same amount, so don't change steps per mm for that.
