Bag Clip
Snap clips for chip and coffee bags
No printer?
Printaro can print this design for you. Copy the link to your design and paste it in your message, so we know exactly which settings you chose.
Keep the tools free
Found this useful?
These generators are free to use. If one saved you time, a small Ko-fi donation helps pay for hosting, rendering and new tools.
About this generator
Keep chips crunchy and coffee fresh. Print a handful in different lengths.
How to use
- Choose the length (about the width of your bags).
- Print on its side as exported.
- Fold the bag top, close the clip until it snaps.
Printing tips
- PETG flexes without snapping; PLA can crack at the loop after a while.
- If the latch is too tight, try a thinner arm.
Helpful guides
Frequently asked questions
How does it close?
It prints open, lying on its side. Squeeze the arms together over the bag until the latch clicks.
The latch is too tight or cracks.
Make the arms thinner for an easier latch. Print in PETG: PLA can crack at the loop after a while.
