Radiator Hook
A towel hook that hangs on the radiator
No printer?
Printaro can print this design for you. Copy the link to your design and paste it in your message, so we know exactly which settings you chose.
Keep the tools free
Found this useful?
These generators are free to use. If one saved you time, a small Ko-fi donation helps pay for hosting, rendering and new tools.
About this generator
Warm, dry towels and no holes in the wall.
How to use
- Pick the kind of radiator and measure its top edge or tube.
- Set how low the hook should hang.
- Print it lying on its side.
Printing tips
- PETG, ABS or ASA. PLA softens on a hot radiator and the hook will sag.
- Print lying flat, as shown: this is the strong direction.
- Leave room behind the radiator: the clamp needs its own thickness between radiator and wall.
Helpful guides
Frequently asked questions
Does it fit my radiator?
Panel radiators: measure the full thickness at the top, including any grille. Towel radiators: measure the tube with a ruler or calipers.
How much can it hold?
A wet bath towel or a coat, in PETG at the default thickness.
