Broom Holder
A wall rail with spring clips for brooms and tools
No printer?
Printaro can print this design for you. Copy the link to your design and paste it in your message, so we know exactly which settings you chose.
Keep the tools free
Found this useful?
These generators are free to use. If one saved you time, a small Ko-fi donation helps pay for hosting, rendering and new tools.
About this generator
Brooms that stand in a corner fall over. Brooms on the wall do not.
How to use
- Measure the handles and set the diameter.
- Choose the number of clips and their spacing.
- Print it on its back and screw it to the wall.
Printing tips
- Print lying on its back plate, as shown: the layers then run around the clips, so they spring and do not snap.
- PETG clips last much longer than PLA.
- Handles of different sizes? Print one rail per size, or set the diameter to the thickest and reduce the mouth.
Helpful guides
Frequently asked questions
The handle slips down. What should I change?
Reduce the handle diameter by 0.5 to 1 mm, or lower the mouth to 60 %.
How long can the rail be?
As long as your bed. Three clips at 70 mm spacing is about 200 mm.
