Bearing Holder
Pillow blocks and flanges for ball bearings
No printer?
Printaro can print this design for you. Copy the link to your design and paste it in your message, so we know exactly which settings you chose.
Keep the tools free
Found this useful?
These generators are free to use. If one saved you time, a small Ko-fi donation helps pay for hosting, rendering and new tools.
About this generator
Mount a shaft on a bearing: pillow blocks hold the shaft parallel to the surface, flanges perpendicular.
How to use
- Choose the bearing.
- Pick pillow block or flange.
- Press the bearing in after printing.
Printing tips
- Print the test fit first: printers vary by a few tenths.
- Press bearings in with a vise, not a hammer.
Helpful guides
Frequently asked questions
Which bearing do I have?
The number is printed on the side of the bearing. The 608 is the common skateboard bearing: 22 mm outside, 8 mm bore, 7 mm wide.
The bearing is too loose or too tight.
Change Fit allowance by 0.05 mm and print again. Printers vary by a few tenths, so print one holder first. Press the bearing in with a vise, not a hammer.
