Wire Spool Holder
Brackets for a rod with spools of wire or solder
No printer?
Printaro can print this design for you. Copy the link to your design and paste it in your message, so we know exactly which settings you chose.
Keep the tools free
Found this useful?
These generators are free to use. If one saved you time, a small Ko-fi donation helps pay for hosting, rendering and new tools.
About this generator
Pull wire straight off the spool instead of from a tangled bag. Add spools by sliding them onto the rod.
How to use
- Set the largest spool diameter and the rod size.
- Print the two brackets flat.
- Screw them to the bench as far apart as the rod is long, slide the spools onto the rod and snap it into the cradles.
Printing tips
- PETG or PLA with 4 walls.
- A threaded rod with nuts against the brackets stops the spools from sliding sideways.
Helpful guides
Frequently asked questions
What do I use as the rod?
A wooden dowel, an aluminum tube or a threaded rod of the diameter you set.
How far apart should the brackets be?
As far apart as the spools you want to hang, plus a few centimeters, and less than the rod length.
