Universal Wall Holder

Cups, boxes, rings and shelves for SKÅDIS, pegboard, French cleat or screws

Measure the thing you want on the wall, choose cup, box, ring or shelf, and pick the system on your wall. You get two parts: the holder, and a wall plate that clips onto SKÅDIS or pegboard, hangs on a French cleat or screws to the wall. The holder slides down onto the plate's dovetail rail. To move it to another wall system, print a different plate.

Free to download. A short ad may play before your file.

One solid body, no colors. Works with every slicer.

Presets
Wall

The plate clips onto your board. The holder slides onto the plate, so you can move it to another system later by printing a new plate.

Holder

Cup for round things (pens, brushes, cans), box for anything square, ring for things that hang by a neck or handle, shelf for anything that stands.

mm

Measure the widest part of what goes in.

mm

For a shelf: the height of the back. The back of every holder is at least 30 mm tall so it sits firmly on the plate.

mm
Extras and colors

A U-shaped opening, handy for cables, long handles or reaching in.

Lets water and dust out: for brushes, sponges or the garden shed.

Advanced
mm
mm

Room in the dovetail between holder and plate. Raise it if the holder doesn't slide on, lower it if it rattles.

No printer?

Printaro can print this design for you. Copy the link to your design and paste it in your message, so we know exactly which settings you chose.

Want your own printer? See which Bambu Lab printer to buy.

Copy link and request a print

Keep the tools free

Found this useful?

These generators are free to use. If one saved you time, a small Ko-fi donation helps pay for hosting, rendering and new tools.

Support on Ko-fi

About this generator

Make a holder that fits exactly what you want to store: a cup, box, ring or shelf sized to the object. Choose your wall system (IKEA SKÅDIS, pegboard, French cleat or screws) and get a matching wall plate. The holder slides onto the plate on a dovetail rail.

How to use

  1. Choose your wall system.
  2. Pick a holder type and enter the size of the object. A little room is added around it.
  3. Add a front cut-out, drain holes or a label if you want.
  4. Print both parts, clip or screw the plate to the wall and slide the holder down onto it.

Printing tips

  • Use the supplied print layout (screw plates lie on their backs). Check overhangs and the slot ceiling in your slicer; supports may be needed.
  • If the holder doesn't slide on, raise Slide fit by 0.05 mm. If it rattles, lower it.
  • Print and test the fit before use. Material, layer adhesion, fasteners and the wall system determine load capacity; no load rating is established.
  • Wide holders get two plates on SKÅDIS and pegboard. Check both are securely engaged.

Helpful guides

Frequently asked questions

Which wall systems does it work with?

IKEA SKÅDIS, pegboard with 1 inch hole spacing (1/4 or 1/8 inch holes), European 25 mm pegboard, French cleat walls, and plain walls with two screws.

Why two parts?

The separate plate adapts the holder to your wall system. With the plate fixed, align the lower slot entrances above the rails and slide the holder down until it stops. Lift upward to remove it. Check print orientation and supports in your slicer.

Can I move a holder to another wall?

Yes. Print a plate for the other system; every plate has the same rail.

How much can it hold?

Load capacity has not been physically verified. It depends on material, print settings, fit, mounting hardware and the wall. Test cautiously with light loads; do not use where failure could cause injury or damage.

Does it work with openGrid or Multiboard?

Not yet. This generator covers SKÅDIS, pegboard, French cleat and screws.