Sanding Block
Hand sanding blocks for strips of sandpaper
No printer?
Printaro can print this design for you. Copy the link to your design and paste it in your message, so we know exactly which settings you chose.
Keep the tools free
Found this useful?
These generators are free to use. If one saved you time, a small Ko-fi donation helps pay for hosting, rendering and new tools.
About this generator
A flat, firm block gives a much more even finish than sanding by hand.
How to use
- Set the pad size: cut your sandpaper to the pad length plus about 2 × the height + 20 mm.
- Print upright as exported.
- Wrap the paper around the pad and tuck the ends into the slots.
Printing tips
- Glue a thin cork or rubber sheet on the pad for a softer touch.
- PETG survives drops better than PLA.
Helpful guides
Frequently asked questions
How does the sandpaper attach?
Wrap a strip of paper around the pad and tuck both ends into the slots on top. Raise Paper slot width for thick paper.
Can I make it softer?
Glue a thin sheet of cork or rubber on the pad before you wrap the paper around it.
