Raspberry Pi / Arduino Case
Snap-lid cases for Pi and Arduino boards
One solid body, no colors. Works with every slicer.
No printer?
Printaro can print this design for you. Copy the link to your design and paste it in your message, so we know exactly which settings you chose.
Keep the tools free
Found this useful?
These generators are free to use. If one saved you time, a small Ko-fi donation helps pay for hosting, rendering and new tools.
About this generator
Pick your board and print: the case has openings for power, video, USB, network and the SD card.
How to use
- Pick the board.
- Add vents and a header opening if you need them.
- Print the case upright and the lid as exported.
- Screw the board onto the standoffs with M2.5 (Pi) or M3 (Arduino) self-tapping screws, then click the lid on.
Printing tips
- Check the cut-outs against your board revision before a long print.
- Add headroom for a HAT or an active cooler.
- PETG or ASA handles a warm Pi 5 better than PLA.
Helpful guides
Frequently asked questions
Does the Pi 5 need a fan?
Under sustained load, yes. Add headroom for the official Active Cooler and choose the honeycomb vents.
Which boards are supported?
Raspberry Pi 5, 4, 3 and Zero, and Arduino Uno and Mega. Check the cut-outs against your board revision before a long print.
