Electronics Enclosure
Project boxes built around your circuit board
One solid body, no colors. Works with every slicer.
No printer?
Printaro can print this design for you. Copy the link to your design and paste it in your message, so we know exactly which settings you chose.
Keep the tools free
Found this useful?
These generators are free to use. If one saved you time, a small Ko-fi donation helps pay for hosting, rendering and new tools.
About this generator
Measure your board, place the connectors and print a box that fits: ESP32, Arduino Nano, relay boards, power supplies.
How to use
- Enter the board size and where its mounting holes are.
- Set how tall the parts on the board are.
- Pick a connector for each wall and slide it into place.
- Print the box upright and the lid as exported.
Printing tips
- Check the cut-outs in the 3D preview against your board before printing.
- Use PETG or ASA near anything that gets warm.
- The standoff holes are sized for self-tapping screws.
Helpful guides
Frequently asked questions
My connector isn't in the list.
Use a round hole or the cable slot, or pick the closest size; the cut-outs have some clearance.
Where is the front?
The front wall runs along the board's length, nearest to you in the preview.
