Cord Lock
Spring-free cord stoppers for hoods, bags and tents
No printer?
Printaro can print this design for you. Copy the link to your design and paste it in your message, so we know exactly which settings you chose.
Keep the tools free
Found this useful?
These generators are free to use. If one saved you time, a small Ko-fi donation helps pay for hosting, rendering and new tools.
About this generator
Replace a broken cord stopper on a jacket, bag or tent without hunting for spare parts.
How to use
- Set the cord diameter and how many cords pass through.
- Print flat.
- Thread the cord through the round end. Slide it into the narrow end to lock.
Printing tips
- PETG is a bit springy and holds longer than PLA.
- If the cord slips, lower the grip by 5%.
Helpful guides
Frequently asked questions
How does it work without a spring?
The narrow end of the slot is smaller than the cord. Pushed in there, the cord gets pinched and stays put. Pull it back to the round end to release it.
Can I use it for two cords?
Yes. Choose Two, for example for both ends of a drawstring.
