Can Rack
A rolling can dispenser for fridge or pantry
No printer?
Printaro can print this design for you. Copy the link to your design and paste it in your message, so we know exactly which settings you chose.
Keep the tools free
Found this useful?
These generators are free to use. If one saved you time, a small Ko-fi donation helps pay for hosting, rendering and new tools.
About this generator
Cold cans, always at the front. No more digging at the back of the fridge.
How to use
- Measure a can and set its diameter and length.
- Choose how many cans the rack holds.
- Print it as it stands and slide it onto a shelf.
Printing tips
- No supports: every part is an upright wall.
- PETG handles the cold and damp of a fridge better than PLA.
- Three standard cans need a rack of about 220 mm. Check the size against your bed and your fridge shelf.
- Two racks side by side fit most shelves.
Helpful guides
Frequently asked questions
Does it work for bottles?
For round bottles that roll, yes: set the diameter and length. Bottles with a neck roll in a curve, so leave them some room.
The cans do not roll. What should I change?
Raise the slope by a degree or two. Wet or dented cans need a little more.
